Differences

This shows you the differences between two versions of the page.

--- linux:system:disk:clone-system [2023/09/08 12:28] – [Get Source Image] oscar
+++ linux:system:disk:clone-system [2023/09/08 12:33] (current) – [Write Target System] oscar
@@ Line 34: / Line 34: @@
 # tar -zcvf image-sdXY.tgz /tmp/source_sdXY
 </code>
-===== Create Targte Disk =====
+===== Create Target Disk =====
 Again, first check with lsblk the disk structure, before proceeding:
 <code>
@@ Line 53: / Line 53: @@
 # gzip -dc efi-image.gz | dd bs=4M of=/dev/sdbX
 # sync
-<code>
+</code>
 ==== Write Root Partition ====
 Empty and create a fresh filesystem on the root partition of the target disk:
@@ Line 99: / Line 99: @@
 Run grub-install against the drive you installed to. In my case that’s /dev/sdb, but this may be different on your machine. Next we install grub to our drive, thereby making it bootable. Be careful to install grub to a drive and not to a partition.
-  # grub-install /dev/sdb
+  # grub-install /dev/sdX
+  # grub-install --recheck /dev/sdX
   # update-grub
@@ Line 148: / Line 150: @@
 </code>
-Alternatively, in case of persistent problems, you can purge and reinstall grub2, make new config files:
-<code>
-apt-get remove --purge grub-pc grub-common
-apt-get install grub-pc
-grub-mkconfig
-update-grub
-grub-install /dev/sda
-</code>
-Now grub is back, all that is left is to exit the chrooted system and unmount everything:
-<code>
-# exit
-# umount /mnt/sys
-# umount /mnt/proc
-# umount /mnt/dev/pt
-# umount /mnt/dev
-# umount /mnt
-</code>
 Shut down and turn your computer back on, and you will be met with the default Grub2 screen.