Differences

This shows you the differences between two versions of the page.

--- esp:esp32:esp-idf-info:architecture-change [2025/02/09 08:11] – oscar
+++ esp:esp32:esp-idf-info:architecture-change [Unknown date] (current) – removed - external edit (Unknown date) 127.0.0.1
@@ Line 1: / Line 1: @@
-====== Architecture Change ======
-----
-Use the following steps to build a project for another architecture:
-Move into the project folder and do a cleanup:
-  idf.py fullclean
-Make a backup of the project folder
-  cd ..
-  cp -r LCR-meter/ LCR-meter-backup
-Move into the project folder and change the architecture:
-  cd LCR-meter
-  idf.py set-target esp32c3
-Setup project configuration
-When setting the target several project settings are returned to defaults. Use **idf.py menuconfig** to check and change settings:
-  idf.py menuconfig
-  Change partition settings to: "Custom partition table CSV"
-  Enable ESP-TLS Server
-  Enable ESP_HTTPS_SERVER component
-  Change Serial Flasher config: Flash size (2 MB)  ---> 4 MB
-Rebuild the project
-  idf.py build
-Check the USB port used by the new board, by running the following command and (un)plugging the USB connector:
-  sudo udevadm monitor -u
-Further we assume that port /dev/ttyUSB0 is being used:
-Do a full flash:
-  idf.py -p /dev/ttyUSB0 flash
-  esptool.py --port /dev/ttyACM0  write_flash --flash_mode qio  0x250000 default.config
-  idf.py menuconfig
-  idf.py partition-table
-  idf.py menuconfig
-  idf.py partition-table
-  idf.py build
-  idf.py -p /dev/ttyACM0 partition-table-flash
-  /home/oscar/development/esp32/idf-tools/python_env/idf5.2_py3.11_env/bin/python ../../esp-idf/components/esptool_py/esptool/esptool.py -p /dev/ttyASM0 -b 460800 --before default_reset --after hard_reset --chip esp32  write_flash --flash_mode dio --flash_size detect --flash_freq 40m 0x0010000 build/LCR-Meter.bin
-  idf.py build
-  python -m esptool --chip esp32c3 -b 460800 --before default_reset --after hard_reset write_flash --flash_mode dio --flash_size 4MB --flash_freq 80m 0x0 build/bootloader/bootloader.bin 0x8000 build/partition_table/partition-table.bin 0xd000 build/ota_data_initial.bin 0x10000 build/LCR-Meter.bin
-  esptool.py --port /dev/ttyACM0  write_flash --flash_mode qio  0x250000 default.config
-  idf.py build