Differences

This shows you the differences between two versions of the page.

--- audio:rew:make-measurement [2025/12/21 18:34] – oscar
+++ audio:rew:make-measurement [2025/12/21 20:31] (current) – [Timing Reference] oscar
@@ Line 13: / Line 13: @@
 {{ :audio:rew-4.jpg?400 |}}
 REW will make a "whoo-oop" sound through your speakers. A short time later, you should see your first in-room measurement and present the measured frequency response in the window.
-{{ :audio:rew-5.jpg?400 |}}
+{{ :audio:rew-5.jpg?600 |}}
 ===== Timing Reference =====
 REW can use an accoustic pulse as a timing reference. Select the option: "Use accoustic timing reference".
-{{ :audio:rew:rew-timing-ref-measure.jpg?400 |}}
+__Note: Timing reference speaker should be the same speakers as the measurement!!__
+{{ :audio:rew:rew-timing-ref-measure.jpg?600 |}}
 Measurements without the option: "Use accoustic timing reference" can be identified as:
-{{ :audio:rew:rew-measurement-without-timing-ref.jpg?400 |}}
-Measurements without the option: "Use accoustic timing reference" can be identified as below. Additional timing information is shown.
+{{ :audio:rew:rew-measurement-without-timing-ref.jpg?300 |}}
-{{ :audio:rew:rew-measurement-without-timing-ref.jpg?400 |}}
+Measurements with the option: "Use accoustic timing reference" can be identified as below. Additional timing information is shown.
+{{ :audio:rew:rew-measurement-without-timing-ref.jpg?300 |}}